• Using an adjustable wrench or a vise, hold the hex on the operator.

• Using a wide blade flat screwdriver, unscrew the copper poppet seal.

• Install the seat in the reverse order.

• Close valve completely to seal it off; See torque information below.

• Loosen the set screw on the torque indicator and rotate to the furthest counter-clockwise line on the top of the valve and tighten set screw. The valve may be closed to this mark going forward.

NOTE: The closing torque will be slightly higher than before.

Do not exceed the maximum torque specification:
• UHV-CF133 Seating Torque; ~130 in-lbs.
• UHV-CF133 Maximum Torque; ~217 in-lbs.

• Periodic checks with a torque wrench will indicate wear on the seat and the proper mark to use for visual alignment.

• When the indicator reaches the last mark, we recommend replacement of the poppet seal.